Today we’re going to be assembling 350 watt solar panel brackets. Before we get started, here are the things that are included: three solar panels (150 watts a piece), eleven brackets total, three hardware bags, and  instructions. You’ll need your own tools and U-bracket, U-bolt brackets,  screws and nuts for mounting this to a pole. […]

Today, we’re going to show you how to set up an automated noise monitoring system out of the case in just a few minutes. Our enclosure has our noise monitoring system inside. Slip that on the tripod with the brackets and tighten them. Take the solar panel and slip it on the back of the

Today we’re going to show you how to set up our Sonitus Automated Noise Monitoring System using one of our many types of tripods. This version is our most portable tripod in one piece. Tighten the bottom, extend the panel and tighten again. Now we have our tripod in place. Charge the 10-day battery pack.

Today we’re going to show you how to calibrate your Sonitus Sound Level Monitor. Log into Sonitus Cloud. This is an automated calibration. The monitor will do it by itself. We just have to put our calibrator on top of the microphone. Take off the windshield on the microphone and place our calibrator firmly on

Today, we’re introducing you to our automated Vaisala Ultrasonic Weather Station, which provides weather data such as temperature, humidity, pressure, wind speed, direction, and rainfall. There are no moving parts, and it’s very easy to service with the Vaisala on top. We have it connected to our WASP Datalogger that sends data automatically to our

Today we’re demonstrating how to replace a PM module in the Aeroqual Dust Sentry or AQS 1 Monitors.   Removing the Module Once you identify the module to be removed, you’ll need to raise the inlet out of the module. To do so, take off the cyclone and TSP heads. Just unscrew the top and

  Today we’re demonstrating how to calibrate your BSWA Sound Level Meter with your Aeroqual Dust Sentry and a CAL200 half-inch calibrator. You can use any half-inch standard microphone field calibrator. The first thing that you want to do is remove the windscreen from the microphone assembly. Look for the upper seam in the windscreen

Today we’re demonstrating how to assemble a 24 Volt lithium iron phosphate battery solar kit with the Delta Link and a simulated solar panel on a benchtop power supply. Installing the Batteries The first thing we’re going to do is take our power extension cables out so we can install our batteries. Take the two

Today, we’re going do a quick overview of the slope monitoring system using load sensing nodes. Equipment (from top to bottom) Vaisala all-in-one weather station – this measures precipitation, temperature, humidity, barometric pressure, wind speed, and direction. Solar panel – this is used to power the weather station. On/Off Switch – behind the solar panel